Professional Dishwasher Repair in Charlotte, NC

Common issues include:

Dishwasher Not Draining Properly

If water remains at the bottom after a cycle, the cause is often a clogged drain hose, blocked filter, or faulty drain pump. We clear obstructions, clean filters, and replace damaged parts to restore proper water flow.
‍

Dishes Not Coming Out Clean

Residue or spots after a full cycle usually mean your spray arms are blocked, the water isn’t heating properly, or detergent isn’t dispensing correctly. We inspect and clean internal components to ensure every load comes out spotless.
‍

Leaking Water From Door or Bottom Panel

Leaks are commonly caused by worn door gaskets, loose hose connections, or a cracked inlet valve. Our technicians locate the exact source and perform a precise seal or part replacement to stop the leak for good.

Dishwasher Won’t Start or Power On

When your dishwasher won’t turn on, it may be due to a blown fuse, faulty door latch, or control board issue. We perform a full electrical check, repair wiring problems, and replace defective components to bring your appliance back to life.

Strange Noises During Operation

Grinding, buzzing, or rattling noises often point to debris caught in the pump or worn bearings in the motor. We disassemble and clean internal parts, tightening or replacing components to restore smooth, quiet performance.

Detergent Not Dispensing

If detergent remains untouched, the dispenser door or wax motor may be faulty, or the timer might be misaligned. We fix the dispenser assembly and ensure the soap releases properly at the right stage of the wash cycle.

Dishwasher Not Drying Dishes

Wet dishes at the end of the cycle typically signal a burned-out heating element, bad thermostat, or rinse aid problem. We test and replace heating parts so your dishwasher dries efficiently again.

Door Not Latching or Sealing Properly

If your dishwasher won’t start because the door won’t close or lock, it’s usually caused by a misaligned latch, bent hinge, or worn gasket. We realign and replace door components for a tight, reliable seal.

Error Codes or Blinking Lights on Display

Modern dishwashers show error codes when sensors detect problems. From water inlet issues to electronic faults, our experts decode the error and repair the root cause quickly to reset your machine.

Dishwasher Stuck Mid-Cycle

A dishwasher that stops before finishing may have a defective control board, thermal fuse, or float switch. We test and replace these parts to ensure smooth, uninterrupted cycles.